Instructions for Installing Custom mod and PTF Files

 Loading PTFs and Custom Code to RMEx
 
Once you have downloaded the program file name to your PC, you must load it into your RMEx program library on your System i5.  

On your PC, enter the following commands to copy the downloaded program files to your iSeries:

Transferring and installing the PTF and custom program files provided by Quantrax to the I-Series

1.Click the start button in the window’s screen
2.Click run
3.Type in CMD and click OK
4.You will be presented with a DOS screen
5.Type CD C:\  and hit ENTER
6.Type in FTP and the IPAddress of the I-Series and hit ENTER
When typed in it should appear as this example:  C:\>ftp 192.169.2.15
7.Type in your I-Series user name and hit ENTER
8.Type in your I-Series password and hit ENTER
9.Type in the word binary and hit ENTER
10.You will now need to key in the command below that corresponds to the program file name and the library where the program file needs to go. Quantrax will provide the Program File Name and Library for the PUT command information
11.Type in the put command below that corresponds with the library provided by Quantrax
(YOU WILL ONLY USE 1 OF THE BELOW “PUT” COMMANDS) (xxxxxxxxxx=the program file name)

If the Library for PUT command is SCFIX you will type in the following:
Put c:\QuantraxSoftware\xxxxxxxxxx SCMOD/@@RCVF.@@RCVF
OR
If the Library for PUT command is SCMOD you will type in the following:
Put c:\QuantraxSoftware\xxxxxxxxxx SCMOD/@@RCV.@@RCV
OR
If the Library for PUT command is SCLIB you will type in the following:
Put c:\QuantraxSoftware\xxxxxxxxxx SCMOD/@@RCVB.@@RCVB

12.Hit ENTER
13.When you see the message that the transfer was successful - Type in quit and hit ENTER


NOTE: Your Smart Code Processer MUST be running; otherwise the changes will not be applied.  
Once the program file has been uploaded using the steps above, it will be copied automatically to the specified library in your system by the Smart Code Program.  
 

keywords: kbase article files iSeries program